sflow collector
Use this command to configure the collector details such as the collector IPv4 address, port number, receiver time-out and datagram size.
Use the no form of this command to disable the sFlow
Sampled Flow data sFlow (sFlow) is the standard for monitoring high-speed switched and routed networks. The sFlow monitoring system consists of an sFlow Agent which is embedded in a switch or router and an sFlow Collector. collector.
Command Syntax
sflow (collector-id <1-5>|) collector A.B.C.D port <1024-65535> receiver-time-out <0-2147483647> max-datagram-size <200-9000> (vrf WORD|)
no sflow collector (A.B.C.D port <1024-65535>|)Parameter
collector-id <1-5>
(Optional) Specifies the name of the Collector instance identifier. If the collector-id is not specified, the ID will be 1.
collector A.B.C.D
Collector IPv4 address. This address must be reachable via the management VRF Virtual Routing and Forwarding.<1024-65535>
port <1024-65535>
Collector UDP User Datagram Protocol Port number. The default port number is 6343.
receiver-time-out <0-2147483647>
Receiver time out value in seconds. Zero means no timeout. Upon timeout, value collector information is removed, stopping any ongoing sampling.
max-datagram-size <200-9000>
Maximum datagram size in bytes that can be sent to the collector.
vrf WORD
(Optional) Specifies the User defined VRF to reach the collector.
Default
Disabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3. Introduced the collector-id and vrf parameters in the OcNOS version 6.5.1.
Example
#configure terminal
(config)#sflow collector 2.2.2.2 port 1111 receiver time-out 30 max-datagram-size 500
(config)#no sflow collectorOcNOS(config)#interface xe12
OcNOS(config-if)#sflow direction ingress
OcNOS(config-if-sflow)#sampling-rate 1024
OcNOS(config-if-sflow)#max-header-size 256
OcNOS(config-if-sflow)#exit
OcNOS(config-if)#sflow enable
OcNOS(config-if)#sflow poll-interval 10
OcNOS(config-if)#sflow collector-id 3