loop-detection-hop-count

Use this command to set the loop detection hop count, which determines the maximum hop-count value.

This command sets the maximum hop count value, which specifies the permitted maximum permitted hop-count. An LSR that detects a maximum hop count behaves as if the containing message has traversed a loop. The use of this command ensures that a loop is detected while establishing a label switched path before any data is passed via LSP.

Use the no parameter to revert to the default loop detection count

Command Syntax

Parameters

<1-255>

Indicates the loop detection hop count.

Default

By default, loop detection hop is disabled

Command Mode

Router mode

Applicability

This command was introduced before OcNOS version 1.3.

Examples