show rsvp session ingress

Use this command to display session-related information for an ingress router.

Command Syntax

Copy

show rsvp session ingress
show rsvp session ingress A.B.C.D
show rsvp session ingress X:X::X:X
show rsvp session ingress detail
show rsvp session ingress down
show rsvp session ingress down detail
show rsvp session ingress up
show rsvp session ingress up detail

Parameters

A.B.C.D

Use this parameter to display an IPv4 address of an ingress router

X:X::X:X

Use this parameter to display an IPv6 address of an ingress router.

down

Use this parameter to display sessions that are currently not operational

up

Use this parameter to display sessions that are currently operational

detail

Use this parameter to display detailed session-related information

Command Mode

Exec mode and Privileged Exec mode

Applicability

This command was introduced before OcNOS version 1.3.

Examples

#show rsvp session ingress (without parameters or with up or down:)

Copy

%s RSVP:
To              From            State                Pri Rt  Style Labelin Labelout LSPName                          Uptime  Est.time   DSType
...
Total %d displayed
 
#show rsvp session ingress detail
Ingress (Primary)
41.41.41.31
From: 29.29.29.29, LSPstate: Up, LSPname: t1-Primary
Ingress FSM state: Operational
Establishment Time: 0s 3ms
Setup priority: 7, Hold priority: 0
CSPF usage: Enabled, CSPF Retry Count: 0, CSPF Retry Interval: 30 seconds
IGP-Shortcut: Disabled, LSP metric: 1
LSP Protection: None
Label in: -, Label out: 24320, ELC

#show rsvp session ingress (with parameters:)

Copy

"Bypass", "Primary", "Detour", "Secondary"
 Make-Before-Break Sibling for session with LSP-ID:    prefix4: prefix6
  From: u.prefix4: u.prefix6
LSPstate: %s, LSPname:
      "Up/"Using Backup"/"Using Secondary"
      "Dn",
  Revert hold timer is ON due to expire in %d seconds
  Revert Timer Finished, Forced Switch to Secondary LSP In Effect
  CSPF usage: "Disabled" : "Enabled"
  CSPF Retry Count: %d, CSPF Retry Interval: %d seconds"
  IGP-Shortcut: Enabled, LSP metric:
  IGP-Shortcut: Disabled, LSP metric:
  LSP Protection:
  Bypass trunk:
  Label in:
  Label out: 
  Tspec rate:
  Fspec rate:
  Policer: Configured
      and installed in hardware
      but not installed in hardware
      Not Configured
  Tunnel Id: %d, LSP Id: %d
Ext-Tunnel Id: 
  Downstream:
  Upstream: 
  Path refresh: %d seconds (RR enabled), (due in %d seconds)
  Path lifetime: %d seconds (due in %d seconds)
  Resv refresh: %d seconds (due in %d seconds)
  Resv lifetime: %d seconds (due in %d seconds)
  Retry count: %d, intrvl: %d seconds", # remaining, next retry in: %d seconds",
  RRO re-use as ERO:  "Enabled" : "Disabled"
  Label Recording: "Enabled" : "Disabled"    
  FRR Admin Groups/Admin Groups:
     ***admin group info***
  Exclude path detail:
   Exclude "Link" : "Node
   Configured Path: "none" : "in use" : "not in use"
   %s Explicit Route Detail  "Configured" : "Received"
       "strict" : "loose"
  Record route: " <self>") "  ...incomplete"
  Style: %s\n", rsvp_style_to_str (style));
  Traffic type:  "guaranteed" : "controlled-load" : "none"
  Minimum Path MTU: 
  Traffic type: N/A
  Minimum Path MTU: N/A
  LSP Type:  "ELSP_SIGNAL" : "ELSP_CONFIG"
  CLASS    DSCP_value     EXP_value
  The class to exp bits mapping is invalid.
  LSP Type:  L-LSP
  LLSP DSCP: %d%d%d%d%d%d   CLASS: %4s",
  DSTE CLass Type Number: Invalid, Class Type name(configured):
  DSTE Class Type Number: %d, Class Type name: 
  Last Recorded Error Code: %s (%d)
  Last Recorded Error Value: %s (%d)
  Node where Last Recorded Error originated:
  Trunk Type: "gmpls" : "mpls"
  Tesid: 
Merge Point Adderss [%d] =
 
 
#show mpls forwarding-table
Codes: > - installed FTN, * - selected FTN, p - stale FTN, B - BGP FTN, K - CLI FTN, t - tunnel
L - LDP FTN, R - RSVP-TE FTN, S - SNMP FTN, I - IGP-Shortcut,
U - unknown FTN, O - SR-OSPF FTN, i - SR-ISIS FTN, k - SR-CLI FTN
 
Code    FEC         FTN-ID Tunnel-id      Pri  LSP-Type   Out- Label  ELC  Out-Intf  Nexthop
R(t)> 2 9.29.29.29/32  1    5001      Yes LSP_DEFAULT   24322    yes
eth2    1.41.41.31
R(t)>   29.29.29.29/32      2   5001       No  LSP_DEFAULT   4322    yes
eth1    69.69.69.42

Table 83 explains the show command output fields.

Table 83.
show rsvp session ingress output field
Field	Description
LSP state	State of the LSP that is being handled by this RSVP session. It can be either Up, Dn (down), or Admin Dn. Admin Dn indicates that the LSP is being taken down gracefully.
LSP name	Name of the LSP.
CSPF usage	CSPF usage state in the rsvp session.
CSPF Retry Count	Number of times CSPF tried to find the path.
CSPF Retry Interval	The interval at which CSPF retry to find the path.
IGP-Shortcut	Status of IGP shortcut for the RSVP trunk.
LSP metric	Relative/Absolute metric value of the LSP.
LSP Protection	LSP Protection configured for the RSVP trunk.
Bypass trunk	Name for the configured Bypass trunk.
Tspec rate	Sender's traffic specification, which describes the sender's traffic parameters.
Fspec rate	Fspec peak rate values.
Policer	QoS Policy configured for the RSVP trunk.
Tunnel Id	Tunnel identifier (destination port) for the RSVP session.
LSP Id	Address of the LSP in the interface.
Ext-Tunnel Id	Ext Tunnel identifier (destination port) for the RSVP session.
Down stream	Specify the dn stream label for the bidirectional label-switched path (LSP).
Upstream	Address of the previous hop for the egress session.
Path refresh	Path messages are sent periodically to refresh path states. The refresh interval is controlled by a variable called the refresh time.
Path lifetime	Number of seconds remaining in the lifetime of the reservation.
Resv refresh	Remaining time in seconds for the next Resv refresh.
Resv lifetime	Number of seconds remaining in the lifetime of the reservation.
Retry count	Number of times sanity polling periodically checks for an error condition in the FPC.
intrvl	Interval sets the time for the messages in order to control the session.
next retry in	Remaining time in seconds for the next retry.
RRO re-use as ERO	Enabling to re-use Record route as Explicit route for rsvp session.
Label Recording	Enabling to record the labels exchanged by all the peers.
FRR Admin Groups/Admin Groups	Resource affinities associated with the rsvp session.
Exclude path detail	Detailed List of the link addresses to be excluded for RSVP Bypass session.
Exclude Link	Address of the Link to be excluded for RSVP Bypass session.
Configured Path	Configured path name associated with the rsvp session.
Record route	Established rsvp path with each hop information.
Style	Reservation style associated with the rsvp session.
Traffic type	Traffic type associated with the rsvp session.
Minimum Path MTU	Path maximum transmission unit (MTU) discovery in the interface.
LSP Type	Type of ELSP signal.
CLASS	Name of the class which is associated with rsvp session.
DSCP_value	DSCP value of diff-serv class which is associated with rsvp session.
EXP_value	EXP value of diff-serv class which is associated with rsvp sess
DSTE Class Type Number	Diff-serv class type number associated with rsvp session.
Class Type name	Diff-serv class type name associated with rsvp session.
Last Recorded Error Code	The last recorded error code for the RSVP session.
Last Recorded Error Value	The last recorded error for the RSVP session.
Node where Last Recorded Error originated	Error originated node in the rsvp session.
Trunk Type	Trunk type in the rsvp session.
Tesid	Traffic Engineering Service Instance Identifier.
Merge Point Adderss	Address of the node where the Bypass LSP joins with the protected LSP.