radius-server login host auth-port
Use this command to configure a RADIUS server and specify a UDP port to use for RADIUS authentication messages.
Use the no form of this command to remove a RADIUS server.
Command Syntax
radius-server login host (A.B.C.D | X:X::X:X | HOSTNAME) (vrf (management|NAME)|) (seq-num (<1-8>)|) (| (auth-port <0-65535> (|(acct-port <0-65535> (|(timeout <1-60>))))))
no radius-server login host (A.B.C.D | X:X::X:X | HOSTNAME) (vrf (management|NAME)|) (seq-num (<1-8>)|) (auth-port (|(acct-port (|timeout))))
Parameters
login
Remote login
A.B.C.D
IPv4 address of RADIUS server
X:X::X:X
IPv6 address of RADIUS server
HOSTNAME
DNS host name of RADIUS server
seq-num
seq-num Sequence Number / Priority index for radius-servers
<1-8>
sequence number for servers
auth-port
UDP port to use for RADIUS accounting messages
<0-65535>
Range of UDP port numbers
acct-port
UDP port to use for RADIUS accounting messages
<0-65535>
Range of UDP port numbers
timeout
How long to wait for a response from the RADIUS server before declaring a timeout failure
<1-60>
Range of timeout period in seconds
vrf
Virtual Routing and Forwarding
vrf NAME
Specify the user-defined VRF instance name.
vrf management
Defines the management VRF instance.
Default
1812.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#radius-server login host 203.0.113.15 vrf management seq-num 1 auth-port 23255