synce-interface

Use this command to enable Synchronous Ethernet for both GPS and 10MHz interfaces as input interfaces. This command changes the mode from interface mode to Synchronous interface Ethernet mode.

Use no form of this command to delete synce interface.

Bits-e1 Applicable only for UFI-S9500-30XS, UFI-S9500-22XST, AS7316-26XB boards.

Bits-t1 Applicable only for UFI-S9500-30XS, UFI-S9500-22XST boards.

Command Syntax

Copy

synce-interface (gps | 10mhz-in|ptp|bits-t1|bits-e1)
no synce-interface (gps | 10mhz-in|ptp |bits-t1|bits-e1)

Parameters

gps

Input interface as GPS

10mhz-in

Input interface as 10MHz

ptp

PTP interface as input-source

bits-t1

bits-t1 interface as input-source

bits-e1

bits-e1 interface as input-source

Command Mode

Interface mode

Applicability

This command was introduced in OcNOS version 4.0.

Example

Copy

(config)#interface eth1
(config-if)#synce-interface gps
(config-synce-if)#
 
 (config)#synce-interface bits-t1
(config-synce-if)#